46
3. Insert the tongue plate of the seat belt into the buckle until it clicks.
4. Pull on the lap belt to take up the slack and ensure a tight fit.
5. Pull out the shoulder belt fully from the retractor and then allow the belt to
retract. The seat belt will lock into place as it retracts.
6. Push the child seat down and toward the back cushion of the vehicle seat,
taking out as much slack from the seat belt as possible.
IMPORTANT
Install the child seat snugly so that its base at the belt path cannot move more
than 1 in (2.5 cm) from side to side. Ensure that the seat is firmly secured before
driving the vehicle.
NOTE
If installing a seat base that accompanies an infant bucket seat, you may need
to clip the seat belt in place with the belt lock off as directed by the seat
manufacturer.
To Next Page
Loading...
