Rize Up - Dual Base Operation; Using Two Bases with One Remote

9
Remote control guide
Using two bases with one remote
Set up both bases and position them next to each other following the instructions
on page 6.
Raise the heads of both beds to access the control systems under the beds.
To operate two Twin XL bases together as one bed.
1
2
Carefully unplug both wired remote controls from the motors on the undersides
of the beds. Place one of the remotes aside, as you will only need one remote to
operate both beds.
Remove one of the pairing cables from one of the bases and extend the cord. Plug
in one of the round output connectors of the pairing cord into head motor on one
of the bases.
Plug the remote control cord into the control input side of the pairing cord.
Plug the other output connector into the motor on the second base.
Before using the adjustable base, move the remote and the cord to the preferred
side of the bed. Make sure that the cords don't interfere with any of the bed's
operations.
Both bases should now operate as one bed.
3
4
5
6
7
8
9
Control input
Output connectors