What to do if my RJH FINISHING SYSTEMS BR won't start?
If your RJH FINISHING SYSTEMS Grinder isn't starting, first, ensure the isolator switch is on. Next, check that the 'E' stop is released. If the issue persists, it may require an electrician.
Why is there no oil feed in my RJH FINISHING SYSTEMS Grinder?
If there's no oil feed in your RJH FINISHING SYSTEMS Grinder, try these steps: First, clear any blockages that might be preventing the oil from flowing. Second, make sure the oil feed is open and not closed. Finally, check the oil level and top it up if necessary.
General| Brand | RJH FINISHING SYSTEMS |
|---|---|
| Model | BR Series |
| Category | Grinder |
| Language | English |
Overview of tool grinder features and included components.
Step-by-step guide for safely unloading and positioning the machine.
Machine weight specs and required operating/maintenance clearances.
Information on connecting the machine to the electrical supply and power requirements.
Overview of inherent safety mechanisms and compliance with directives.
Discussion of vibration levels, noise, and necessary protective measures.
Specifies essential Personal Protective Equipment (PPE) required for safe operation.
Guidelines for safe operation, prohibitions, and general machine care.
Detailed steps for sharpening chisels and plane blades using the machine.
Instructions on sharpening gouges, including the use of the radius attachment.
Guidance on using the cone wheel for burr removal on Bear2 models.
Procedure for maintaining grinding wheel shape and effectiveness using a dresser.
General advice on machine upkeep, lubrication, and cleaning procedures.
Guidelines for grinding wheel fitting, testing, selection, and maintenance.
Step-by-step guide for safely changing grinding wheels with necessary precautions.
General assessment of machine risks and the importance of safe practices.
Identification and evaluation of potential hazards during machine operation.
Dimensional drawing and footprint specifications for the Bear1 model.
Dimensional drawing and footprint specifications for the Bear2 model.
General information on neat cutting oils, including composition and hazards.
Detailed product data sheet for honing fluid, including typical test data.
Company contact details, including address, phone, fax, email, and website.
To Next Page