EasyManua.ls Logo

RM Gastro REDFOX FP 36 - Instruction for Use

RM Gastro REDFOX FP 36
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY MEASURES FROM THE STANDPOINT OF THE FIRE
PROTECTION ACCORDING TO EN 061008 ČL. 21
• only adults can operate the device
• device must be safely used in common surroundings according to EN 332000-4-462; EN 332000-4-42. You
must switch the gas device off under the circumstances leading: to the danger of the temporary rise of the
combustion gas or steam or during works when there is a big possibilityof rise ot the temporary re danger
or explosion (for example: to stick linoleum, PVC etc.).
• before you start to instal the device you must get the licence for connection to the gas feeder from the
gasworks
• device must be placed so as to stand or hang on the noncombustible surface which is on each side 10
cm larger than the device. No subjects from combustible materials can be placed directly on the device
or in distance which is shorter than safety distance (the shortestdistance is 50 cm in the direction of the
heat emission and 10 cm in other directions).- safety distances from various materials of different degree of
combustion and information about the degree of comb. of common building materials - see chart:
Chart:
Combustion degree of building materials classifi ed according to the combustion degree of materials and
products (EN 730823)
A noncombustible granit, sandstone, concretes,bricks, ceramic wallfacing tiles, plaster
B uneasily combustible akumine, heraklite, lihnos, itavere
C1 hardly combustible leafy wood, plywood, sirkoklit, rare paper formica
C2 middle combustible breboards, solodure, cork boards, rubber,fl oor-coverings
C3 easily combustible wood-fi breboards, polystyrene,polyurethane, PVC
Devices must be instalated in a safe way. When instaling you must respect corresponding project, safety and
hygienic orders according to:
EN 061008 re protection of local devices and sources of heat
• EN 332000 (33 2000-4-482; 33 2000-4-42) surrounding for electric devices ČSN EN 1775 Gas supplying
Gas ttings in the buildings - the highest operational pressure < 5 bar - operation demands
• § 10 law nr. 185/2001 Sb. about waste
INSTRUCTION FOR USE
Attention
Before the fi rst use of the device you must remove protection foil from all surfaces and wash the device
with moist cleaning cloth.
In order to switch on the oven, turn clockwise the knob (A) of the timer until reaching the requested time of
cooking from 0 to 15 minutes. The orange light (B) turns on to signal that the appliance is on. In order to
use the oven without timing, you can choose the manual mode by turning the knob unclockwise until pointer
is in the position ON. To regulate the temperature of the oven, turn clockwise the thermostat knob (D) until
reaching the requested temperature between 50 and 300 degrees. When temperature is reached, the
green light (c) turn off. To turn off heating elements before set time, turn slowly timer knob unclockwise until
reaching the 0 position. Také care, as forced operation can damage it seriously!
Open and close the door using the handle. Avoid putting hands in when the oven is on or is still hot. Use
gloves or appropriate accessories for this purpose.
C
B
A
D
Behavior timers
The timer is operated as follows: when setting the timer you must turn it to a setting of over
3 minutes. The elements only start after the timer is set to over 3 minutes. If you wish to set
the timer to less than 3 minutes, you must initially turn it to over 3 minutes and then turn it
back to e.g. 2 minutes.
The alarm (bell) will sound a minute before the timer reaches the time it is set to. This is
standard behaviour for the timer.
7