Need help?Do you have a question about the RME Audio DIGIFACE and is the answer not in the manual?
General| Connectivity | USB 2.0 |
|---|---|
| Bit Depth | 24-bit |
| Power Supply | USB bus-powered |
| Category | Audio Interface |
| Sample Rate | 192 kHz |
| SPDIF | Yes |
| Word Clock | Yes |
| MIDI | 1 x MIDI I/O |
| Clock Modes | Internal, ADAT, SPDIF, Word Clock |
Specifies technical details for digital audio interfaces, jitter, and sample rate capabilities.
Details connectors, clock sources, and supported formats for digital audio connections.
Specifies the technical characteristics of the analog output stage, including levels and frequency response.
Explains the bit depth, transfer modes, and internal data handling of the system.
Details the power supply requirements, voltage range, and current draw for the system.
Step-by-step instructions for installing the PCI card into a computer system.
Instructions for installing the CardBus card into a notebook's PCMCIA slot.
Describes the physical connections for the front and back panels of the Digiface I/O box.
Explains how to perform digital recording and the system's features for input monitoring.
Provides an overview of the Hammerfall DSP Settings dialog and its configurable options.
Explains how to set up clock modes and synchronize the system using AutoSync and other references.
Details the technical background and practical application of word clock for synchronization.
Covers the types of cables and impedance matching required for word clock distribution.
Describes the general operation of word clock signals and related status LEDs.
Provides general guidance and examples for operating the system with ASIO 2.0 compatible software.
Discusses performance aspects like channel count, buffer sizes, and disk performance for ASIO.
Explains how to achieve sample-accurate synchronization between ADAT recorders and ASIO.
Lists common issues with ASIO operation, synchronization, and potential causes.
Describes the different components, controls, and visual layout of the TotalMix mixer interface.
A step-by-step guide for creating submixes and routing signals within the TotalMix mixer.
Explains the Submix View mode for simplifying mixer overview and routing channel selections.
Details the functionality and behavior of the Mute and Solo buttons for audio channels.
Lists and explains useful keyboard shortcuts for efficient operation of TotalMix controls.
Describes additional options and features in the Quick Access Panel for TotalMix control.
Explains the preset system for saving and recalling TotalMix mixer configurations and states.
Details the level meter functions, display options, and setup within TotalMix and DIGICheck.
Addresses common troubleshooting topics like ADAT timecode sync, input signal issues, and channel problems.
Troubleshoots common installation problems, such as hardware detection and playback failures.
Shows a block diagram illustrating the internal components and signal flow of the Digiface I/O unit.
Illustrates signal paths and routing configurations for ADAT tracks in ASIO double speed mode.
Displays a signal flow diagram for the TotalMix mixer, clarifying input and output routing within the Digiface.
To Next Page