3. Copy the complete sub-folder Hammerfall DSP, found in the folder 'into Preferences folder',
to the system folder 'Preferences'. This way the files related to the HDSP system reside in their
own folder, without cluttering the Preferences folder. Additionally deleting those files is much
easier in case of a driver update. Hammerfall DSP contains 10 files:
default.mix: Default settings for TotalMix
default.vol: Default settings for Digiface/Multiface, as long as TotalMix isn't started
preset1.mix to preset8.mix: Presets for the HDSP mixer
4. The file Hammerfall DSP TotalMix can be copied to any place. When started the HDSP
mixer comes up and allows you to configure the digital real-time mixer of the Digiface.
TotalMix requires Carbon Library 1.1, which is part of the operating system since MacOS
9.1. After installation of Carbon Library 1.1 TotalMix can even be run on older systems
(down to 8.6).
5. Using the MIDI ports of the Digiface requires an installed OMS (Open Music System) from
Opcode. The latest version 2.3.8 can be downloaded for free at
http://www.opcode.com
After the installation of OMS, copy the file HDSP_OMSDriver, found in the folder 'into OMS
Folder folder', into the system folder 'OMS Folder'.
To finish installation reboot the computer.
After re-boot the MIDI driver is installed, but not yet activated. To activate it create a new OMS
Studio setup. Using 'Search' the MIDI driver of the Digiface should be found and added to the
list. Now it can be activated.
Linux/Unix
An ALSA driver for Linux/Unix is planned to be available soon. Further information on ALSA is
available at
http://www.alsa-project.org
To Next Page
Loading...