RME Audio Fireface UCX II - Digital Outputs

110
User's Guide Fireface UCX II © RME
Word Clock
 BNC
 Internal termination 75 Ohm switchable
 Automatic Double/Quad Speed detection and internal conversion to Single Speed
 SteadyClock guarantees super low jitter synchronization even in varispeed operation
 Not affected by DC-offsets within the network
 Signal Adaptation Circuit: signal refresh through auto-center and hysteresis
 Overvoltage protection
 Level range: 1.0 Vpp – 5.6 Vpp
 Lock Range: 27 kHz – 200 kHz
 Jitter suppression: > 50 dB (2.4 kHz)
39.5 Digital Outputs
AES/EBU
 XLR, transformer-balanced, galvanically isolated, according to AES3-1992
 Output level Professional 4.5 Vpp, Consumer 2.6 Vpp
 Format Professional according to AES3-1992 Amendment 4
 Format Consumer (SPDIF) according to IEC 60958
 Single Wire mode, sample rate 28 kHz up to 200 kHz
SPDIF coaxial
 1 x RCA, according to IEC 60958
 Output level Professional 1.2 Vpp, Consumer 0.6 Vpp
 Format Professional according to AES3-1992 Amendment 4
 Format Consumer (SPDIF) according to IEC 60958
 Single Wire mode, sample rate 28 kHz up to 200 kHz
ADAT
 1 x TOSLINK
 Standard: 8 channels 24 bit, up to 48 kHz
 Double Speed (S/MUX): 4 channels 24 bit 96 kHz
 Quad Speed (S/MUX4): 2 channels 24 bit 192 kHz
Word Clock
 BNC
 Max. output voltage: 5 Vpp
 Output voltage @ 75 Ohm termination: 4.0 Vpp
 Output impedance: 10 Ohm
 Frequency range: 27 kHz – 200 kHz
39.6 General
 Power supply: external power supply
 Typical power consumption: 13 Watts
 Current at 12 Volt operating voltage: 910 mA (11 Watts)
 Dimensions incl. rack ears, full depth (WxHxD): 265 x 44 x 155 mm (10.5" x 1.73" x 6.1")
 Dimensions without rack ears, body depth (WxHxD): 215 x 44 x 130 mm (8.5" x 1.73" x 5.1")
 Weight: 910 g ( 2.0 lbs)
 Temperature range: +5° up to +50° Celsius (41° F up to 122°F)
 Relative humidity: < 75%, non condensing