To Next PageTo Next Page
Need help?Do you have a question about the RME Audio Hammerfall Multiface II and is the answer not in the manual?
General| Audio Interface Type | PCI |
|---|---|
| Number of Inputs | 8 |
| Number of Outputs | 8 |
| Connection Type | PCI |
| Sample Rate | 192 kHz |
| Bit Depth | 24-bit |
| AD/DA Conversion | 24-bit/192 kHz |
| MIDI I/O | Yes |
| Word Clock I/O | Yes |
| Bus Power | No |
| Analog Inputs | 8 |
| Analog Outputs | 8 |
| Word Clock | Yes |
| Form Factor | Rackmount |
| Phantom Power | No |
| Software | TotalMix |
| Digital Inputs | ADAT, SPDIF |
| Digital Outputs | ADAT, SPDIF |
| Digital I/O | ADAT, SPDIF |
Overview of the RME Hammerfall DSP system and its capabilities.
Details the necessary hardware and software for the system.
Guides on physically installing the PCI or CardBus interface.
Basic steps to get the system operational for initial use.
Lists optional accessories available for the HDSP system.
Instructions for installing and updating system drivers and firmware.
How to adjust settings like sample rate, sync, and I/O.
Explains how to use the Multiface for playback, recording, and different modes.
Provides solutions for common problems and support contact.
Instructions for installing and updating drivers and flash firmware on Mac.
How to adjust settings like sample rate, sync, and I/O on Mac.
Common questions and answers for Mac users regarding the system.
Provides solutions for common problems and support contact for Mac.
Information on using the Multiface in standalone or disconnected operation.
Details on connecting analog audio signals to the device's inputs and outputs.
Information on setting up ADAT, SPDIF, Word Clock, and MIDI connections.
How to mix and route signals using the TotalMix software.
Explains the matrix view for routing and gain control.
Highlights advanced features like ASIO Direct Monitoring and MIDI control.
References to further detailed technical information and resources.
Lists detailed hardware specs for analog and digital interfaces.
Explains underlying concepts like synchronization, latency, and signal formats.
Visual representations of signal paths and connector pinouts.
