33. Technical Specifications
33.1 Analog
AD
• Resolution: 24 bit
• Signal to Noise ratio (SNR): 107.5 dB RMS unweighted, 111.5 dBA
• THD: < -100 dB, < 0.001 %
• THD+N: < -98 dB, < 0.0012 %
• Channel separation: > 100 dB
• Frequency response AD @ 44.1 kHz, -0.5 dB: 5 Hz – 21.0 kHz
• Frequency response AD @ 96 kHz, -0.5 dB: 5 Hz – 45.3 kHz
• Input: 6.3 mm TRS jack, electronically balanced
• Input impedance: 10 kOhm
• Input sensitivity switchable to Lo Gain, +4 dBu, -10 dBV
• Input level for 0 dBFS @ Lo Gain: +19 dBu
• Input level for 0 dBFS @ +4 dBu: +13 dBu
• Input level for 0 dBFS @ -10 dBV: +2 dBV
DA
• Resolution: 24 bit
• Dynamic Range (DR): 109 dB RMS unweighted, 112 dBA
• THD: < - 100 dB, < 0.001 %
• THD+N: < -97 dB, < 0.0014 %
• Channel separation: > 110 dB
• Maximum output level: +19 dBu
• Frequency response DA @ 44.1 kHz, -0.5 dB: 5 Hz – 20.9 kHz
• Frequency response DA @ 96 kHz, -0.5 dB: 5 Hz – 45.8 kHz
• Output: 6.3 mm TRS jack, servo-balanced
• Output impedance: 100 Ohm
• Output level switchable Hi Gain, +4 dBu, -10 dBV
• Output level at 0 dBFS @ Hi Gain: +19 dBu
• Output level at 0 dBFS @ +4 dBu: +13 dBu
• Output level at 0 dBFS @ -10 dBV: +2 dBV
Stereo Monitor Output
• Maximum output level at 0 dBFS: +17 dBu
• Dynamic Range: 116 dB (RMS unweighted, unmuted), 119 dBA
• THD+N: -100 dB / 0.001 %
• Channel separation: > 110 dB
• Frequency response DA @ 44.1 kHz, -0.5 dB: 5 Hz – 20.8 kHz
• Frequency response DA @ 96 kHz, -0.5 dB: 5 Hz - 44 kHz
• Output impedance: 30 Ohm
33.2 Digital
• Low Jitter Design: < 3 ns external clock, < 1 ns internal clock
• Internal sample rates: 32 / 44.1 / 48 / 88.2 / 96 kHz
• Supported sample rates through word clock: 28 kHz - 103 kHz
• Internal resolution: 24 bit
• Input PLL ensures zero dropout, even at more than 40 ns jitter
• Bitclock PLL for trouble-free varispeed ADAT operation
• Ground-free digital inputs and outputs
To Next Page
Loading...
