rnib.org.uk
Using the product
Setting the volume
Press the Talk button on top of the clock to hear the time
announcement. You can then increase or decrease the volume by
using the rotary dial on the back.
Setting the clock
To set the time and/or alarm, or to activate the optional hourly
announcement, follow these instructions.
The square Mode button is used to enter the menu. To change the
settings of the function selected press the round Set button. At any
time during set up you can press the large Talk button to return to
current time announcement mode or you can simply proceed to the
next function by pressing the Mode button once more.
As you press the Mode button the menu is announced in the
following order:
Activating the hourly time announcement
Press the Mode button and the clock will say "announce off".
Press the Set button and the clock will say "announce on".
Pressing the Set button when in this mode will toggle between on
and off. When activated, the clock will announce the time on the
hour every hour.
Setting the alarm
Press Mode again and you will enter the alarm setting. The clock
will announce "alarm off". To change to “alarm on” press the Set
button. Set the alarm time by pressing the Mode button again. The
clock will say "alarm hour" followed by the actual alarm hour
setting (e.g. "alarm hour 6"). Change this by pressing the Set
button. The clock will announce each alarm hour as you cycle
through them. Press Mode to advance to the alarm minutes. The
clock announces "alarm minute" followed by the current alarm
minute setting. Change this using the Set button. Note: To
advance the minutes quickly press and hold the Set button and the
To Next Page
Loading...
