RoadEyes recneo - F. Start; Stop Recording; Power On and Recording Status; Audio Recording Control

7
F. Start / Stop Recording
After powering up the unit and a display device connected properly,
the display will show the welcome screen as below follow up
Firmware Version: XXXX. Then enter the live mode.
OSD screen when Power-on
★The OSD and led lights may vary in different models.
1. Power on / Recording
Wait about one minute after power-on, After machine booted-up,
the red light will be flashing; the icon will appear top right of
the screen, that means start recording.
Red Light

Steady flashing: normal recording.

Rapid flashing: force recording.
Green Light
 Flashing green light: GPS registering.
 Steady green light: indicates GPS
re
g
istered.
2. Audio recording On/Off
In the LIVE screen you can choose whether to open the audio
recording or not, click the mute button on the remote control, the
icon will appear top right of the screen, that means stop audio
recording; When the icon appears in the top right that says
the audio recording is on.