7 English
DIRECT USB ENCODING
Remark:
• Recording speed is 1:1.
• No song title will be recorded during encoding mode.
• To avoid damage to USB memory, remove it only when the radio is turned off.
ENCODE FROM FM, DAB, TURNTABLE, TAPE, BLUETOOTH AND AUX:
1. Plug the USB stick into the [USB PORT] (3);
2. Perform normal playback of the source you want to encode & record;
3. Press the [RECORD] button (14) to start encoding. The display will show “REC”;
4. Once the record is finished, press the [STOP] button (9) to stop recording.
ENCODE FROM CD:
1. Plug the USB stick into the [USB PORT] (3);
2. Perform normal playback of the CD you want to encode & record;
3. After focus search is completed, press the [RECORD] button (14);
4. Press repeatedly the [SKIP -/+] button (10/11) to select the desired encoding op-
tion:
• REC-ONE: Select to record only the current track;
• REC-DIRECTORY: Select to record the whole folder;
• REC-ALL: Select to record all the tracks of the CD.
5. Press the [RECORD] button (14) to confirm;
6. The playback will stop and restart automatically and on the display “REC” will
flash. Encoding is performing now;
7. Press the [STOP] button (9) to finish recording.
Note: After completing of encoding, unit will stop playback and encoding automatical-
ly.
DELETE TRACKS FROM USB
1. Perform normal playback of the track you want to delete;
2. During playback of the track you want to delete, press and hold [DELETE] (14).
3. Press repeatedly the [SKIP -/+] button (10/11) to select the desired encoding op-
tion:
• DEL-ONE: Select to record only the current track;
• DEL-DIRECTORY: Select to record the whole folder;
• DEL-ALL: Select to record all the tracks of the CD.
4. Press the [DELETE] button (14) to confirm.
SYSTEM SETTINGS
Long press [MENU] (15) button, select desired menu with [SKIP -/+] button (10/11)
and confirm with [SELECT] (9) button.
Alarm: setting alarm function. Time: setting time
Backlight: Set the time of full display time and the brightness level .
Language: Set a different language
Factory reset: Restore to factory settings. Software Upgrade: not in use
SW version: shows the current software version
To Next Page
Loading...
