5 English
DAB RADIO SETTING
During DAB radio mode, press and hold the menu button , lcd will show “full scan”,
then press [SKIP -/+] (11/10) repeatedly to select below:
Full scan: press [SCAN] button (8) to confirm, unit will automatically scan those
available dab stations.
Manual tune: press select button to confirm, then press pressing [SKIP -/+] button
(11 / 10) to select dab radio frequency manually, press select button again to confirm
if desired frequency is found.
Press and hold [MENU/MODE] (15) button, you can choose with [SKIP -/+] (10/11)
buttons and confirm your selection with [SELECT] (9) button:
Full scan: unit will automatically scan those available dab stations.
Manual tune: , then press pressing [SKIP -/+] (10/11) buttons to select dab radio fre-
quency manually, press [SELECT] (9) button again to confirm if desired frequency is
found.
DRC: Press [SKIP -/+] (10/11) buttons repeatedly to select “off”, “low” and “hgih”, then
press [SELECT] (9) button to confirm. the selected option will show “＊” at the right
side of lcd.
PRUNE: Press [SKIP -/+] (10/11) buttons repeatedly to select “yes” and “no”, press
[SELECT] (9) button to confirm. this is used to cancel all invalid stations after full
scan.
CD-MP3 OPERATION
1. Select “CD” mode by pressing the [MODE] button (2) repeatedly;
2. Press [OPEN/CLOSE] (7) to open the [CD DOOR] (6) and place a CD with the
label up in the CD compartment.
3. Close the [CD DOOR] (6). Focus search is performed and playback will start au-
tomatically from the first track.
PROGRAMMING
Up to 99 tacks (MP3, 20 in CD) can be programmed and play in any order.
1. Stop the playback by pressing [STOP] (9);
2. Press [MEM/MODE] (16), the display will show the number of the track
on the left side and the number of program on the right side.
3. Select desired track by using [SKIP -/+] buttons (10/11);
4. Press [MEM/MODE] (16) to confirm desired track into the program
memory;
5. Repeat step 3 and 4 to enter additional tracks into the program memory.
6. When all the desired tracks have been programmed, press [PLAY] (8) to play the
disc in the order you have programmed.
Note: Press [STOP] (9) twice to terminate programmed play.
TAPE OPERATION
1. Select “TAPE” mode by pressing the [FUNCTION] button (2) repeatedly;
2. Press [EJECT] (23) to open the [CASSETTE SLOT] (18) and insert your tape;
3. Close the [CASSETTE SLOT] (18);
4. Press [PLAY] (20) to start playing tape.
• Press [PAUSE] (24) when you want to stop playing tape operation temporarily,
press again to resume tape operation.
To Next Page
Loading...
Need help?
General
