5 English
REPEAT
To play a single track continuously, disk continuously or folder (MP3 only) press [EQ/
RPT] button (10), you can select Rep-1, REP-ALL or REP-DIR (MP3 only).
Pressing again [EQ/RPT] button (10), you can select RANDOM function..
PROGRAMMING
You can program tracks for disc play in any order.
Stop the playback by pressing [STOP] (4);
Press [PROG] (21), the display (1) will show “P01” and flash;
Select desired track by using [TUNE -/+] buttons (5/6);
Press [PROG] (21) again to confirm desired track into the program memory;
Repeat step 3 and 4 to enter additional tracks into the program memory;
When all the desired tracks have been programmed, press [PLAY] (3) to play the disc in
the order you have programmed;
Press [STOP] (4) twice to terminate programmed play.
USB OPERATION
Select “CD” mode by pressing the [FUNCTION] button (2);
Plug an USB device into the [USB SOCKET] (16);
Playback will start automatically from the first track.
PROGRAMMING
The PROGRAMMING operation is the same as that of CD-MP3.
Note: Some mp3 player may not be able to play via the usb socket. this is not a maul-
function of the system.
Note: To avoid damage to USB memory, remove it only when the radio is turned off.
AUX IN OPERATION
Select “AUX” mode by pressing the [FUNCTION] button (2);
Use one male to male 3.5mm jack cable (not included) to connect any external audio
device to the AUX-IN socket (17).
Note: Music control (play, pause, etc) must be done from your external device.
To Next Page
Loading...
Need help?
General
