English English
5 6
• Press SET button (3) again to select the day
• Turn the Tune + / - knob to set the correct day
• Press SET button (3) to confirm the calendar setting
ALARM SETTING
Make sure the POWER switch is set to the 'Off' position. The time or alarm time cannot be
set or adjusted while the unit is 'On'.
• Press theAlarm button (13) and select the Alarm 1 orAlarm 2
• Press the SET button (3) and the display will show the minute 00 will flash and press Tune
+/- to select the minute.
• Press the SETbutton (3) againto confirm setting, thenthe Display will show 00:00 andthe
first 00 will flash, then press Tune +/- to select the correct hours.
• Press SET button (3) to confirm the alarm setting
• PressALARM button (13) to enter in normal clock mode
ALARM OFF
DuringAlarm on, press SET button (3) or ON/OFF button (11). The alarm sound goes off but
theAlarm setting remains.
ALARM VOLUME SETTING
• InRadioAlarm, theAlarmVolumeissetwiththelast volumelevel used during playback.
• In BuzzerAlarm, theAlarm level isfixed.
WAKE TO BUZZERALARM
• Alarm 1 andAlarm 2 both have “wake to buzzerAlarm” function
• Set theAlarm time as shown above
• Turnthe Tuning knob to setAlarm to wake up to Buzzer alarm
WAKE TO MUSIC
• Repeatthe steps ofAlarmTime Setting,Alarm 1 andAlarm 2 both have the “wake to music”
function.
• Press theAlarm button (13) once to set the desired Alarm 1 time
• Press theAlarm button (13) twice to set the desired Alarm 2 time
• Turn the Tune+/- knob once after alarmsetting to activate wake to Radio function
• After finish theAlaem 1 or Alarm 2 time setting, press the SETbutton (3) once to confirm
alarm timer setting
• The Radio Memoryicon appear in the display. Duringthat time, turnthe Tuning+/- knob to
select the desired Radio station stored in tehe memory before
• Press the Set button (3) to confirm
• Press the ON/OFF button (11) toturn ON the unit, then adjust the Volume to the desired
level.Press theON/OFF button (11) toswitchOFFtheRadio,then it switch ONautomatically
at the preset Alarm time
SNOOZE / SLEEP
SLEEP FUNCTION
• PressONbutton(11)toswitch ONtheradio. PresstheSnooze /SleepButton (7)sequentiually
to display will show90, press again is 80/70/60/50.....10, then press again is off.
• Afterset the Sleep function and when finish, then the unit willoff automatically.
SNOOZE
The alarm can be temporarily turned off manually by pressing the SNOOZE button; the alarm
will turnback on 5 minutes later automatically.
This feature can be repeated endlessly.
HEADPHONES
Headphones should have a 3.5mm diameter stereo plugandanimpedanceof8-32 ohms.When
headphonesare connected (8), thespeaker is automatically disconnected.
SPECIFICATIONS
Power Supply
AC: 230V~ 50Hz
DC: 4 x UM3 Battery
Radio Frequency Coverage
FM: 88 -108 MHz
MW: 540 - 1600 kHz
SW: 3,16 - 18.10MHz in 10 bands
Speaker 4 Ohms, 3-5 W
Ouputpower: 0.8 W RMS, 10% THD
General
Headphone: 3.5mm jack plug, 8-32W
Impedance 32 Ohms
Specifications and the design are subject to possible modifications without notice due to improvement.
To Next Page
Loading...
Need help?
General
