2
English
- Objects have fallen into or liquids has been spilled into the radio;
- The appliance has been exposed to rain;
- The appliance has been dropped or the enclosure damaged;
- The appliance does not appear to operate normally.
•
SERVICING - The user should not attempt to service the appliance beyond that
descrive in the user operating instructions. All the servicing should be referred to
qualified service personnel
Note: If the display does not function properly or no reaction to operation of any
control may due to the electrostatic discharge. Switch off and disconnect the AC cord
and remove all the batteries, then turn the power back on after a few seconds.
POWER SOURCES
AC POWER: You can power stereo system by plugging the AC/DC adaptor into the
DC plug (17) at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
TO USE THE RADIO
1. Press the [POWER] button (1) to power on the unit;
2. Select the desired audio source by pressing the [MODE] button (2) repeatedly;
3. (Please see detailed instructions for each Source in the following chapters);
4. Adjust the volume with the [VOLUME KNOB] (3) to the desired level;
5. Press the [POWER] button (1) to turn OFF the unit.
Note: When no sound is produced, the unit will switch OFF automatically after 10 mi-
nutes.
TURNTABLE OPERATION
1. Select “PHONO” mode by pressing the [MODE] button (2) repeatedly;
2. Place a record on the turntable. Place the EP adapter over the central spindle
when playing 45 rpm records;
3. Set the [SPEED SELECTOR] (21) to 33, 45 or 78 rpm according to the record;
4. Release the tonearm clamp, and remove the stylus protector;
5. Lift up the [TONEARM] (22) with the [LIFT LEVER] (19);
6. Move the [TONEARM] (22) to the beginning of the record;
7. Lift down the [TONEARM] (22) with the [LIFT LEVER] (19);
8. When the record is finished the plate will automatically stop turning. To stop ma-
nually, lift up the tonearm from the record and return it to the rest support;
Note: Do not stop or turn the plate manually.
When the unit is moved or transported:
•
Lock the [TONEARM] (22) with the tonearm clamp.
•
Place the protective cap on the stylus (even when not in use).
To Next Page
Loading...
Need help?
General