Utilities
46
© 2014 by Roadtrek, Inc.
Tank selector valve in exterior tank
position
Tank selector valve in interior tank
position
•• To fill the interior tank only, close the tank isolator valve and set the tank selector valve to the interior position. The interior
fill is located in the rear door on the right side. With the tank isolator valve closed, running water into this fill port will fill
the interior tank only - approximately 10 gallons.
•• To fill both interior and exterior tanks, open the tank connection valve and set the tank selector valve to the exterior
position. Fill exterior tank first, then interior tank.
Roadtrek recommends that you use a dedicated single purpose potable-water hose. These are usually white in color.
Buy a new one and use it only for filling your tanks and connecting to city water. View any hose lying around a
campground with extreme skepticism, especially it there's a wastewater dump nearby. Large RVs use hoses to flush
their wastewater system. Always flush faucet and hose thoroughly before use.
To Next Page
Loading...
