ECO User Guide
© 2010 Stanley Security Solutions, Inc. All Rights Reserved. October 2010. 980-000009-000 Rev 04
Tel: USA: 800-824-2996 Canada: 866-559-6275 Int’l: +1 (613) 592-6997 Web: www.stanleyhealthcare.com
Stanley Security Solutions Stanley Healthcare Solutions Division 1550 N. 20th Circle, Lincoln, NE 68503
The Access Keypad
The Keypad provides four separate
functions:
• Local audible and visual alarms
• Bypass function to escort residents
through the protected exit
• Alarm reset when the Controller
is in continuous alarm mode or
resets the bypass sequence
• Controller status indication via
the LED indicators
The Controller may be bypassed or reset
at an exit point by entering a 3- to 7-digit
code at the keypad.
Status Indicator Condition Cause Action
Power
OFF Power is o Turn Power ON
Solid Yellow Power ON, Ready Mode None; system ready
Bypass
Flashing Green/Red + Beeping tone Bypass Mode Escort resident immediately
Alarm
Flashing Red + Beeping tone Alarm Mode Investigate; reset alarm
Escorting Residents (Bypass)
1. Bring the resident to the exit, ensuring that he or she is not in the detection zone.
2. Enter the <BYPASS CODE> on the keypad.
3. Press <#> on the keypad.
4. Escort the resident through the exit.
Note: There are three automatic timers enabled by the system when the bypass function is activated:
• Bypass Timeout: You have 10 seconds to enter the detection zone after the bypass code is entered. If no
tag enters the zone within the 10-second period, the bypass is terminated.
• Transport: Once the tag enters the detection zone, you have 90 seconds to transport the resident through
the zone before the alarm is activated.
• Rearm: After the tag is through the zone or the door closes, the system automatically resets itself in 8 seconds.
Reset an Alarm
• Enter the <Reset Code> on the keypad and press <#>.
Clear or Correct an Entry
• To clear or correct an entry, press <*> on the keypad.
Power
(Yellow LED)
Bypass
(Green LED)
Alarm
(Red LED)
Clear Function Enter Function
To Next Page
Need help?
General