If you have problems, please try as following:
Outdoor Sensor
For a more accurate reading and weather forecast, please place the
sensor at a proper place:
1.Avoid exposing to direct rain, sunlight or other heat/cold source.
2.Make sure there is enough air flow around the sensor to reflect the
changes of environment (Well-ventilated).
3. Make sure there ain’t a thick wall or strong interference source using
same signal frequency (433.92MHz) between the weather station and
the sensor.
4. Place the sensor vertically at the height about 1.5m-3m / 4.9ft-9.8ft.
5. When the sensor is first used or relocated, let it stand for around one
hour or more before having accurate measuring of temperature and
humidity.
6. You can place the sensor in multi ways: hang from the back hole using
a nail, place on a stable surface, or lift with a rope. In whatever way,make
sure at least one side of the air vent (back or bottom) is not blocked.
1. Turn off any other existing wireless equipment to check whether this is
the cause of the problem.
2. Move any other existing wireless equipment. Shorten the distance
between the sending and receiving devices and reduce the number of
obstacles(walls, furniture,etc.) between them.
3. Try to remove and reassemble batteries, if the batteries are old, try
new ones.
To Next Page
Loading...