MAIN UNIT INSTALLATION
1. Remove the battery compartment cover.
2. Insert 3 x AA batteries matching the correct polarity (+and-)
(Not included).
3. Connect the adaptor with power.
SENSOR INSTALLATION
1. Remove the battery compartment cover, according to the number
marked on the surface of the sensor, dial to the corresponding
channel.
2. Insert 2 x AA batteries matching the correct polarity (+ and -)
(Not included), the red led light will flash for once, then assemble
the battery compartment.
3. Put the sensor to the position you desire.
1. Install batteries for main unit first, then install batteries for
Remote sensor immediately with same channel.
2. After power-on, the LCD will display for 3 seconds, and at the
same time it will start to detect the indoor temperature and humidity,
then the air pressure value, and then start to receive RF signals for
3 minutes, and finally enter the RCC reception.
3. If you want to get a better look , please tear off the transparent
protective film of the host.
To Next Page
Loading...