Euclidean
Rhythm
You can also use the module as
an euclidean rhythm generator.
Add a clock source to the CV
input and the tripot will output
trigger signals.
You can dene per channel how
long the sequence should be
and how many pulses are sent
in this time. With the rotation
parameter you can move the
sequence in time.
c Clock Input
1 2 3 Channel
d e f Display Active Trigger
g
h
i Steps 1 to 16
j
k
l Pulses 1 to 16
m
n
o Offset
p
q
r Trigger Output
Sequencer
You can use the module as
a step sequencer. Connect
a clock source and let the
sequencer play melodies with
up to 8 steps. You can set the
note values from trimmer 1 all
the way clockwise to trimmer 4.
The middle trimmer 5 denes
the length of the sequence.
The sequencer outputs the
linear voltage on channel
one. The voltages are output
chromatically on channels two
and three. The sequence will be
split if you reduce the number
of steps and output separately
on channel two and channel
three.
c Clock Input
d Current Step
e Clock Display
f Current Note
g
h
i Step 1, 2, 3
j
k
l Step 8, 4
m
n
o Step 7, 6, 5
p
q
r CV Output Lin, Chr
To Next Page
Loading...