To Next PageTo Next Page
Need help?Do you have a question about the Robertshaw 700 Series and is the answer not in the manual?
General| Brand | Robertshaw |
|---|---|
| Model | 700 Series |
| Category | Valve Positioners |
| Language | English |
Details electrical ratings for different model types: 24 Volt, Millivolt, and Line Voltage.
Identifies wiring block colors for control voltages like 24 Volt, 120 Volt, and 240 Volt.
Specifies regulator details for Natural Gas and L.P. Gas, including factory settings.
Lists the temperature ranges for Hydraulic models.
Provides conversions between dial positions and temperature for Hydraulic models.
Specifies the capillary lengths for Hydraulic models.
Details the bulb outside diameter and length for Hydraulic models.
Mentions pilot outlet size and tubing specifications.
States the operating ambient temperature limits for the control.
Specifies the maximum allowable inlet pressure for safe operation.
Instructions for gas piping, ensuring cleanliness, pressure testing, and drip leg installation.
Guidance on connecting pilot tubing, ensuring it's free of burrs and dirt.
Details on the regulator vent, vent limiter, and bleed tubing requirements.
Instructions for connecting the thermocouple nut and setting the lock washer.
Notes on capillary handling, sensing bulb position, and remote dial installation.
Checks for correct operating voltage and appliance compatibility.
Explains wiring standards, thermopile compatibility, and lead wire length recommendations.
Warning against shorting terminals and instructions for 24 Volt models.
Guidance on transformer selection and wiring connections for 24V systems.
Procedure for performing a leak test using soap solution after installation.
Crucial safety precautions before lighting the pilot and handling gas.
Instructions for turning the temperature dial and gas cock dial.
Guidance on replacing the control if exposed to water.
Lists common causes of pilot outage and outlines testing procedures.
Procedure to check thermocouple output using a millivolt meter.
Tests pilot magnet operation if the pilot fails to remain lit.
Guidance on checking millivolt system components with a meter.
How to adjust the pilot key for a properly sized flame on the thermocouple.
Procedure for field adjustment of the pressure regulator.
Instructions for converting the regulator between Natural gas and L.P. gas.
Details on replacing the regulator assembly or valve operator.
Instructions for removing the 'slow opener' disc if needed.
