Robertshaw SLIMZONE CLASSIC 2701-001 User Manual

Robertshaw SLIMZONE CLASSIC 2701-001

19 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

SLIMZONE CLASSIC

2701-001 / 2701-006

ZONE CONTROL SYSTEM

INSTALLATION AND OPERATION

MANUAL

Questions and Answers:

D
Daniel HoodJul 31, 2025
What to do if there is no heat or cooling in my house with Robertshaw SLIMZONE CLASSIC 2701-001 Control Systems?
- R
  rodriguezjenniferJul 31, 2025
  If you're experiencing a lack of heating or cooling in your home, here are a few potential causes and solutions: * **Zone thermostat(s):** Verify that the COOL/OFF/HEAT switch on your thermostat(s) is correctly set. * **Faulty heating/cooling equipment or thermostat:** Troubleshoot the equipment or thermostat according to the manufacturer’s instructions. Replace the thermostat if necessary. * **Faulty zone control panel:** Follow the instructions outlined in the Setup and Test section. Replace the panel if necessary. * **Improper remote switch selector setting (if installed):** Make sure the switch is set to a mode that allows the requested call to be serviced.
L
Lori BlakeAug 14, 2025
Why is there no heat or cooling in a specific zone with Robertshaw Control Systems?
- P
  Patrick JonesAug 14, 2025
  If a specific zone lacks heating or cooling, consider the following possibilities: * **Balancing damper closed:** Check all balancing dampers in the same duct as the motorized zone damper and readjust any that are closed. * **Zone registers closed:** Inspect all zone registers and readjust any that are closed. * **Faulty thermostat:** Troubleshoot the thermostat according to the manufacturer’s instructions. Replace if necessary. * **Faulty zone control panel:** Follow the instructions outlined in the Setup and Test section. Replace the panel if necessary.

Robertshaw SLIMZONE CLASSIC 2701-001 Specifications

General

Type	Zone Control System
Model Number	2701-001
Compatibility	Compatible with most HVAC systems
Number of Zones	Up to 4 zones
Power Supply	24 VAC
Display	LED

Summary

Introduction and Safety

General Safety Instructions for Installation

Provides crucial safety warnings regarding installation, sharp edges, and static discharge.

Component Requirements and Sizing

Thermostat and Transformer Specifications

System Installation Procedures

Control Panel Door Installation and Removal

Installation Details and Wiring

Backplate Mounting and Thermostat Installation

System Wiring and Damper Requirements

Damper and Bypass System Installation

Bypass Damper System Purpose and Selection

Bypass Damper Installation Location

Advanced Installation and System Protection

Barometric Bypass Damper Setup Procedures

Motorized Bypass Damper Control and Wiring

Current Limited Output Terminals and Protection

Details the self-resetting current limiting device (polyfuse) and its function.

Importance of High and Low Limit Control

System Operation Overview

Initial Power Up and Mode Establishment

Describes initial panel behavior and how system mode (HEAT, COOL, AUTO) is determined.

Operational Sequence and Timing Controls

Details the sequence of damper activation, minimum run times, and fan purge cycles.

Mode Changes and Control Panel Setup

Mode Change Logic and Sequence

Describes how the system changes mode based on thermostat calls and delay timers.

Control Panel Slide Switch Functions

Lists the functions of slide switches for heat/cool and heat pump system configurations.

LED Status Indication and Operation Checklist

LED Reference for System Status Verification

Provides a table detailing LED reference, color, location, and function for system verification.

Operation Verification and Checklist Items

Lists checks for proper configuration, installation, and adjustment of system controls.

Setup and Testing Procedures

Cooling Cycle Test Procedures

Instructs on power disconnection, setting cooling setpoints, and observing LED indications.

Heating Cycle Test and Post-Test Actions

Details the heating cycle test, LED indications, and restoring normal operation.

Troubleshooting Guide

Troubleshooting No Heat/Cooling in House

Lists common causes and solutions for lack of heating or cooling in the entire house.

Troubleshooting No Heat/Cooling in Zone

Related product manuals

Preview: Robertshaw SlimZone Premier

Robertshaw SlimZone Premier