Need help?Do you have a question about the Robin SOLRISEN EY15D and is the answer not in the manual?
General| Brand | Robin |
|---|---|
| Model | SOLRISEN EY15D |
| Category | Utility Vehicle |
| Language | English |
Avoid inhaling exhaust gasses containing dangerous carbon monoxide. Operate in well-ventilated areas.
Handle gasoline with care due to flammability. Stop engine before refueling, avoid overfilling, and wipe spills.
Do not operate near open flames or smoking. Keep engine clear of flammable materials and maintain 1-meter clearance.
Guard rotating parts. Be aware of hot surfaces. Avoid touching spark plug during operation or adjustments.
Steps for starting: set stop switch, fuel valve, speed control, and operate recoil starter correctly.
Adjust choke gradually after starting. Warm up engine at low speed, then set to desired operating speed.
Idle engine at low speed for 1-2 minutes. Turn off stop switch and close fuel valve to prevent issues.
Diagnose no-start issues: check compression, spark plug wetness, and fuel supply to carburetor.
Verify stop switch is ON, inspect spark plug condition, and test spark strength by pulling starter.
Perform before operation: check fuel, oil, leaks, bolts, air cleaner, and surroundings for safety.
Essential for engine longevity and performance. Follow interval chart based on operating hours.
Clean spark plug, check and adjust electrode gap (0.6-0.7mm), and use specified plug types.
Change engine oil when warm. Drain, refill with recommended oil, and follow initial/periodic change intervals.
Capacity: EY15/20 models require 0.6 L, EY28 models require 0.85 L.
Inspect fuel strainer for contaminants. Remove, clean with gasoline, and reinstall securely to prevent leaks.
Maintain air cleaner cleanliness to prevent performance loss and engine damage. Clean or replace elements as needed.
Periodically retighten all fasteners and check for fuel/oil leaks. Replace worn or damaged parts.
Replace fuel hoses every two years or immediately if any leaks are detected for safety.
Check battery electrolyte level and refill with distilled water if it falls below the designated line.
Empty fuel tank and carburetor if storing engine for over one month to prevent fuel system gumming.
Change engine oil and add a small amount to the cylinder to prevent corrosion during storage.
Thoroughly clean the engine, protect it with a cover, and store in a dry, well-ventilated indoor area.
To Next Page