ROBINHOOD RHCD7W - Troubleshooting; Display Issues; Indicator Light Issues; Dryer Not Starting

17
Troubleshooting
Alarm Problem
Alarm Reason
Release
“ E30 ”
Heating problem
Please contact your local service center if the problem persists.
“ E32 ”
Humidity sensor error
“ E33 ”
Temperature sensor error
• Only authorised technicians can carry out repairs.
• Before you call service, please check if you have dealt with the fault yourself or if you
have followed the user instructions.
• A technician will charge you for advice, even during the warranty period.
Problem
Solution
• Display does not on
• Check if the power supply works.
• Check if the mains plug is inserted.
• Check the selected program.
• Press the 【On/Off】button.
• “ ”is lighting
• Empty water container.
• If the light is still on, please call the service.
• “ ”is lighting
• Clean heat exchanger.
• Clear lint filter.
• Dryer does not start
• Check the door has closed.
• Check the program has set.
• Check the start button has selected.
• Degree of dryness was not
reached or drying time too
long
• Clean lint filter and heat exchanger.
• Empty container.
• Check drain hose.
• Dryer installation place is too restricted.
• Clean the moisture sensors.
• Keep the Air inlet clean.
• Use higher drying intensity level program or time
program.
If you cannot deal with the fault by yourself and need help:
• Press the 【On/Off】button.
• Pull out the mains plug and call the service
Warning!
Warning!