ROBOOTER E40 - Using the Electric Wheelchair; Operation Notices

17
4. U
sing the Electric Wheelchair
4.1 Notice for Use
Please carefully read the Product Manual before use and check whether the
parts are in good condition to ensure your safety;
When the electric wheelchair is operated for the first time, level and hard ground
shall be selected as soon as possible to ensure that your sounding area has no
barrier or pedestrian;
Do not remove the motor and the upper controller by yourself. If replacement is
required, please purchase the original parts from the authorized agent;
If the electric wheelchair is artificially modified, the use of non-original parts will
be exempted from the warranty liability;
Do not give the electric wheelchair to minors or other people who are not
suitable for the electric wheelchair;
Do not overload (the maximum load of the electric wheelchair is 330 lbs); the
electric wheelchair is limited to 1 person;
Make sure that the electric wheelchair is already fully expanded;
Make sure that you have fastened the electric wheelchair seat belt;
When you sit correctly in the electric wheelchair and gently push the upper
controller rocker, the electric wheelchair will move forward, back, turn left or turn
right; The electric wheelchair will be stopped after the release. Practice this basic
function until you are skilled;
During steering, please clear the barriers nearby;
Please obey the traffic rules and drive in the non-motorized lane to ensure the
safety of you and others. Please drive slowly and Do not take others;
When the electric wheelchair is operated in a relatively harsh environment (e.g.,
when entering or turning), the electric wheelchair should be operated slowly. It is
recommended to minimize to the lowest speed of the electric wheelchair in harsh
environments;
Check whether the electric wheelchair is in good condition, such as whether the
performance is normal;
The electric wheelchair will automatically shut down if being idled for 30 minutes;