05
Open the Roborock app, tap the "Add
Notes:
•
The actual process may vary due to ongoing app
updates. Follow the instructions provided in the app.
•
Only 2.4 GHz WiFi is supported.
•
If the vacuum cleaner waits more than half an hour for
a connection, WiFi will be automatically disabled. If you
want to reconnect, reset the WiFi before proceeding.
C1-1—Grip the clean tank handle, press the
release button, and gently pull the
clean tank upwards at a slight angle.
Instructions for Use
C
C1
Filling the Clean Tank
a. Keep the vacuum cleaner upright and
press the
button. The LED display will
turn on, and the vacuum cleaner will be
on standby.
b. Press and hold the
and buttons
simultaneously until you hear the
"Resetting WiFi" voice message. The
reset is complete when the WiFi indicator
on the LED display flashes slowly. The
vacuum cleaner will then wait for a
connection.
If you cannot connect to the vacuum cleaner due
to your router configuration, a forgotten password, or
any other reason, reset the WiFi and add your vacuum
cleaner as a new device.
Note:
2. Reset WiFi
3. Add Device
C1-2—Open the cap of the clean tank refill
port, add tap water, and then close
the cap.
C1-3—Open the cap of the cleaning solution
refill port, add compatible cleaning
solution, and then close the cap.
Notes:
•
To avoid deforming the clean tank, only use cold water.
•
To prevent corrosion or damage, do not use
any disinfectant and only use cleaning solutions
recommended by Roborock.
•
To improve cleaning performance, we suggest that
you add the recommended cleaning solution to
the cleaning solution refill port before use. During
cleaning, the machine will automatically add cleaning
solution to clean water based on the preset ratio.
C1-4—Place the clean tank back to the
cleaner head. Push it down gently
until it clicks into place.
Pull the handle to unlock the vacuum
cleaner, and press the
button to start it.
Always lay the vacuum cleaner flat with the
buttons on the handle facing up.
Note:
C3
Starting the Vacuum Cleaner
C4
Lay-Flat Cleaning
Press the button to switch between AUTO,
MAX, ECO, and Sponge modes. The screen
will display the icon of the current mode.
C5
Mode Switching
C2
Locking and Unlocking
The vacuum cleaner can be laid flat to
clean under furniture. To lay it flat on the
floor, lower the handle while using the
machine. The available capacity of the dirty
tank decreases during lay-flat cleaning.
Therefore, it is recommended to empty the
dirty tank before cleaning under furniture.
1. Press the
button during cleaning to
pause the vacuum cleaner. It is now on
standby.
Standby and Power off
C2-1—Locked
C2-2—Unlocked
Search for "Roborock" in the App Store
or Google Play or scan the QR code to
download and install the app.
Connecting to the App
1. Download the App
Device" or "+" button and add your device
following the in-app guide.
Lightly step on the cleaner head and hold the
handle. Push it to lock the vacuum cleaner,
and pull it to unlock the vacuum cleaner.
To Next Page
Loading...
