24
PROBLEMS
At first, try to identify precisely what has caused the
power mixer to stop.
• If it is due to a powercut if the appliance has
been unplugged
- Release the control button (CB).
- Check the power supply.
- Restart the power mixer following the paragraph
entitled OPERATING THE APPLIANCE (page 18).
• If it is due to overheating of the machine
- Release the control button (CB).
- Unplug the power mixer.
- Wait a few minutes for the motor to cool down
and the thermal safety mechanism to be reset.
- Restart the power mixer following the paragraph
entitled OPERATING THE APPLIANCE (page 18).
• If you cannot locate the cause of the problem
- Release the control button (CB).
- Unplug the power mixer.
STANDARDS
Consult the declaration of compliance on page 3.
REMINDER
Never try to override the locking and safety
mechanisms.
Never insert an object into the preparation.
Never switch the appliance on unless it has been
placed in the preparation bowl.
Before dismantling the foot and bell, always
check that the power mixer is unplugged.
We recommend that you tilt the power mixer at
a slight angle to prevent the bell from touching
the bottom of the container.
- Check :
- the plug
- that the blades are free to rotate in the bell,
- the state of the power cord,
- that the drive shaft is free to rotate. To do this,
remove the bell and test the rotation of the end of
the drive shaft manually.
If a malfunction occurs which is not on our list of
possible faults, consult your retailer or return the
appliance to the after-sales service.
To Next Page
Loading...
