Installation, use and maintenance manual – M gas unit heater
3
I Introduction .............................................................................
p.4
I.1 Recipients ..........................................................................
p.4
I.2 Control device ..................................................................
p.4
II Symbols and denitions ...............................................
p.4
II.1 Key to symbols .................................................................
p.4
II.2 Terms and denitions ....................................................
p.4
III Warnings......................................................................................
p.4
III.1 General and safety warnings ......................................
p.4
III.2 Conformity ........................................................................
p.5
III.3 Exclusions of liability and warranty ..........................
p.6
1 Features and technical data ......................................
p.7
1.1 Features ..............................................................................
p.7
1.2 Dimensions .......................................................................
p.8
1.3 Electrical wiring diagram .............................................
p.9
1.4 Controls ............................................................................
p.11
1.5 Electrical panel ...............................................................
p.13
1.6 Technical characteristics .............................................
p.13
2 Transport and positioning ........................................
p.15
2.1 Warnings ..........................................................................
p.15
2.2 Handling ...........................................................................
p.15
2.3 Appliance positioning .................................................
p.15
2.4 Minimum clearance distances..................................
p.16
2.5 Support bracket .............................................................
p.16
3 Heating engineer ...............................................................
p.17
3.1 Warnings ..........................................................................
p.17
3.2 Fuel gas supply ..............................................................
p.17
3.3 Combustion products exhaust ................................
p.18
3.4 Air ducting .......................................................................
p.21
4 Electrical installer ..............................................................
p.22
4.1 Warnings ..........................................................................
p.22
4.2 Electrical systems ..........................................................
p.22
4.3 Electrical power supply ...............................................
p.22
4.4 Control system ...............................................................
p.22
5 First start-up ..........................................................................
p.24
5.1 Preliminary checks ........................................................
p.24
5.2 Burner pressure adjustment .....................................
p.25
5.3 Gas changeover .............................................................
p.27
6 Normal operation ..............................................................
p.27
6.1 Warnings ..........................................................................
p.27
6.2 Switch on and o ..........................................................
p.27
7 Maintenance ..........................................................................
p.28
7.1 Warnings ..........................................................................
p.28
7.2 Scheduled routine maintenance .............................
p.29
7.3 Resetting the temperature limit thermostat .......
p.29
7.4 Periods of inactivity ......................................................
p.29
7.5 Troubleshooting ............................................................
p.29
INDEX OF CONTENTS