9
EN
Simptom Solution
The dryer does not work
Ensure there is power in the electrical circuit of the unit.
Turn off the power and remove the cover. Verify that the dryer is powered,
checking the voltage on the terminal block.
Verify that there are no loose or badly fixed cables.
Verify that the button is not stuck.
If none of the previous steps solve the problem, contact the Technical Service.
The dryer works but cold
air comes out
Turn off the power and remove the cover.
Verify that there are no loose or badly fixed cables.
If none of the previous steps solve the problem, contact the Technical Service.
The dryer suffers self-
activations
Verify that the button is not stuck.
If the previous step does not solve the problem, contact the Technical Service.
The dryer heats up but
air does not flow
Turn off the power and remove the cover. Clean the motor of possible particles
that impede its movement.
If this intervention does not solve the problem, contact the Technical Service.
The dryer works but you
hear a buzz sound
Turn off the power and remove the cover. Clean the motor of possible friction
particles during motor movement.
If this intervention does not solve the problem, contact the Technical Service.
The dryer works but you
hear a rattle (fast ticking)
Turn off the power and remove the cover. Clean the motor of possible friction
particles during motor movement.
Check the condition of the motor brushes and replace if necessary.
If this intervention does not solve the problem, contact the Technical Service.
TROUBLESHOOTING