Rocal GALA - Page 11

11
1.1 Specifications
Parameter
Value
Minimum - Maximum draught 11-13 Pa
Fuel consumption 4.7 kg / h
Smoke mass flow rate 13 g / s
Performance 81 %
Nominal output
17.5 kW
Maximum power
22 kW
Average CO concentration at 13% of O2 0.16%
Particle concentration 45 mg / Nm3 13% O2
Payload (trial) 3.8 Kg
Reload interval period (trial) 48 min.
Medium draft (trial) 12 Pa
Net weight 297 Kg
Maximum authorized load (fuel) 6 Kg
Reload height 250 mm
Logs length 400 mm
Minimum flue height 4000 mm
Ø Flue liner 200 mm
Ø Outside Air inlet ducts 120 mm
Perimeter safety distance 1000 mm
Primary register (trial) 35% open
Secondary register (trial) 50% open
Average temperature of smoke 258º C
Type of combustion INTERMITTENT
Flue liner NOT SHARED
Fuel NATURAL WOOD
Humidity fuel logs 12-20% - two years under cover
Certification year 2010
Certificate No.:
LEE/030/10
1.2 Breakdown of delivery components
(Make sure you have all the components described below in relation to the picture on section II of the ANNEXED
document)
1.
Fireplace’s body: Doors kit, base and inner hood
2.
Flue liner connector
3.
Chimney cap
4.
Ceiling crest
5.
Floor base plates
6.
Envelope with 3 documents: specifications, installation and operation manual, and Guarantee sheet.
7.
Silicone tubing
8.
Upper vermiculite baffle plate
9.
Lower vermiculite baffle plate
10.
Tool for handling registers and opening doors
11.
Cleaning cloth
12.
Bag with screws and anchors: 6 screws, 6 anchors.
13.
Fire Base plates
14.
Outer hood
15.
Heat-resistant glove
16.
Heat-resistant spray paint for touch-ups
1.3 Diagram of the equipment's measurements
See the ANNEXED document, section I, page 1.
1. SPECIFICATIONS