You should have the main Rocker BMX
assembly, some bars with pre installed
grips, a pair of pedals (one stamped L the
other stamped R) and a seat post unit. If
anything is missing, now is the time to let
us know.
To make life easier, we are going to first
install the pedals. First off the left hand
pedal stamped ‘L’ using the 15mm
spanner. Please note, to tighten a left
pedal you turn anti clockwise NOT
clockwise. Be careful not to cross thread
and make sure the pedal is done up nice
and tight. Running loose pedals destroys
the threads very quickly.
Now, carefully remove the stem faceplate
bolts x 4 with a 6 mm allen key. Ensuring
the correct orientation, hang the
handlebars in the stem bar recess and
carefully replace the stem faceplate. Be
very careful to ensure the faceplate is
tightened evenly.
With the left pedal installed you can now
stand the bike up using the left pedal as
a bike stand. This makes the job a lot
easier. Now install the right hand pedals,
this time the pedal is turned clockwise to
tighten. Again be careful not to cross
thread the pedal and make sure the
pedal is done up nice and tight.
You can now easily pop the seat in, set
the desired height & tighten with a 5 mm
allen key. You will need to turn the bolt a
good 5 + rotations before it will start to
go tight for the first time.
To Next Page
Loading...