RocketFish RF-MONO70C User Manual

RF-MONO70C
I
70" Carbon Fiber Monopod
Quick Setup Guide
# Component Description
1 Quick-release mounting plate Mount your device to this removable plate.
2 1/4" screw Tighten to secure your device to the mounting plate.
3 Mounting base plate Clamp the quick-release mounting plate to this base plate.
4 Variable angle head ball Allows the head to be adjusted to any angle.
5 Safety lock pin Prevents the mounting plate from falling out when the quick
release clamp knob is released.
6 Pan locking knob Locks the horizontal movement of the head.
7 Quick-release plate locking knob Locks the quick-release mounting plate to the tripod.
8 Head ball locking knob Sets the head at dierent angle. Loosen to permit movement
of the head ball. Tighten to stop movement of the head ball.
Package contents
• Monopod with pan head
• Mounting plate
Note: mounting plate is on the pan head.
• Wrench (1)
• Quick Setup Guide
Important safety instructions
• Make sure that all levers, handles, knobs, and leg locks are correctly
tightened before use.
• Do not carry or transport the monopod with camera equipment attached
(for example, over your shoulder or cradled in your arms).
• Do not store or expose your monopod to excessive heat or cold, or use near
any ame or re.
• Do not oil or grease any part of the monopod.
• Do not use any solvents or thinners to clean your monopod.
Use only a mild detergent and wipe dry with only a soft, lint-free cloth.
• Do not exceed the load limit of this product. (See Specications)
Features Using your monopod
To set up your monopod:
1 Unscrew the leg locks and extend the leg to the desired
length.
2 Tighten the leg locks to adjust the monopod to the desired
height.
Caution: Incorrectly securing a leg lock can cause the
monopod leg to retract unexpectedly and could result in
damage to the monopod or to the attached camera or
camcorder.
3 To remove the mounting plate, unscrew the quick-release
plate locking knob, then press the safety lock pin and lift the
plate away from the head.
4 Secure your camera or camcorder to the mounting plate
with the 1/4" screw on the bottom of the plate. Tighten the
screw rmly to avoid unintended lateral movement of your
device.
Specications
One-year limited warranty
Visit www.rocketshproducts.com for details.
Contact Rocketsh:
For customer service please call 1-800-620-2790
www.rocketshproducts.com
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Richeld, MN 55423-3645 USA
© 2010 BBY Solutions, Inc., All Rights Reserved. ROCKETFISH is a trademark of BBY
Solutions, Inc. All other products and brand names are trademarks of their
respective owners.
ENGLISH 10-0540
Minimum Maximum Maximum Maximum
Folded operating operating tube Net load
Model height height height diameter weight capacity
RF-MONO70C 22.8 in 22.8 in 70 in 1.14 in 1.82 lbs. 20 lbs.
(579 mm) (579 mm) (1778 mm) (29 mm) (820 g) (9 kg)

RocketFish RF-MONO70C Specifications

General

Brand	RocketFish
Model	RF-MONO70C
Category	Camera Accessories
Language	English