20
Distributed by Rockler Companies, Inc.
Medina, Mn 55340
67865 69218 61601
Rev 07/21
> The bed will not stay down without the weight of
a mattress. You MUST have an adult helper hold
down the bed to avoid the risk of serious personal
injury from the bed suddenly slamming shut.
> Do NOT use a foam or very light mattress with this
product. See required weight specifications on p. 3.
> TO AVOID THE RISK OF SERIOUS INJURY,
DO NOT ALLOW CHILDREN TO PLAY ON
THE BED UNIT OR OPERATE IT WITHOUT
ADULT SUPERVISION.
WARNING
Using your Murphy Bed
Check Rockler.com for updates. If you have further questions, please
contact our Technical Support Department at 1-800-260-9663
or support@rockler.com
1. Once the bed unit has been assembled correctly and
secured to the wall, pull the bed down and, while
holding the frame securely, pivot the Leg assembly
so that it will support the frame when it is
fully lowered.
2. Have an adult helper hold the bed frame down while
you slide the mattress onto the frame.
3. To return the bed to the cabinet, hold the frame and
pivot the Leg assembly up and over the side of the
mattress. The Leg assembly serves as a mattress
retaining system.
4. Using the handles on the Door Panels, slowly
and carefully allow the bed to tilt up into the cabinet.
Final Check of Bed Cabinet Installation
Locations for 1/4" x 3" Washer Head Lag Bolts (KK) installed through
Lower Headboard into wooden wall studs are obscured by mattress in
this illustration; see Page 11 for locations
Wall Brackets (HH) bolted
into wooden wall studs
Stud Locations
1/4" x 3"
Washer Head
Lag Bolts
(KK) installed
through
Upper
Headboard
into wooden
wall studs
Stud and
lag bolt
locations in
this image
are for
illustration
purpose
only.
To Previous Page
