Rockler Wixey WL133 - User Manual

To Next Page

WL133 Drill Press Laser

Wixey Drill Press Laser mounts quickly on any drill press. It has thin and precise easy

to adjust crosshairs.

Drill Press Laser Instruction

1. Install 2 AA batteries as shown

2. Attach the laser to the drill press column using the hose clamp (A)

3. Adjust the X-Y position of the lines using Knobs (B) and the Z position using

screws (C)

Need help?

Do you have a question about the Rockler Wixey WL133 and is the answer not in the manual?

Summary

Install 2 AA batteries as shown.

Attach the laser to the drill press column using the hose clamp (A).

Adjust the X-Y position of lines using Knobs and Z position using screws.

Draw a vertical line on wood using a square and place it on the table.

Adjust the Z position of laser lines to be parallel to the reference line.

Lay wood face down and make a small indentation with a drill bit.

Adjust the X-Y position of laser lines to cross at the indentation.

General