Do you have a question about the Rockpals R2000i and is the answer not in the manual?
Explains the necessity and procedure for grounding the generator.
Warns against blocking cooling vents, which can damage components.
Lists included accessories for the generator.
Explains the operation of the red engine switch for starting and stopping.
Describes the yellow oil warning light and its implications for engine operation.
Explains the red overload indicator light and actions to take when it illuminates.
Describes the green AC pilot light indicating power generation status.
Details the function and operation of the DC protector.
Explains the Eco-Mode Idle Control Switch for fuel efficiency and noise reduction.
Describes how to operate the fuel tank cap air vent knob for fuel flow.
Explains the purpose and connection of the ground terminal for safety.
Detailed instructions on checking and adding engine oil before operation.
Provides guidance on selecting the correct type and viscosity of engine oil.
Step-by-step guide for safely adding unleaded gasoline to the fuel tank.
Explains the process of properly grounding the generator for electrical safety.
Provides sequential steps for initiating the generator engine.
Guides on how to properly pull the recoil starter to engage the engine.
Explains the function and usage of the Eco-Mode Idle Control Switch.
Sequential steps to safely shut down and stop the generator.
Outlines essential checks to perform before starting the generator.
Instructions for checking the engine oil level before each use.
General guidelines for connecting and operating electrical devices with the generator.
Steps for connecting devices and checking indicators after powering on.
Advice on selecting appropriate extension cords based on power requirements.
Sequential steps for safely connecting loads to the generator's AC outlets.
Cautions regarding sparks, battery gas, and electrolyte handling during charging.
Emphasizes the importance of routine maintenance for generator longevity.
Specific cautions regarding oil changes and air filter cleaning under various conditions.
Procedures for changing or adding engine oil, including safety precautions.
Instructions for draining the fuel tank and carburetor for storage or maintenance.
Guidance on how to inspect and check the spark plug for proper operation.
Specifies the correct torque for installing the spark plug.
Advises leaving carburetor adjustments to authorized service personnel.
Step-by-step guide for removing, cleaning, and re-installing the air filter.
Instructions for removing, cleaning, and reinstalling the fuel tank filter.
Guidelines for safely storing and transporting the generator.
Steps to protect the engine from corrosion during long-term storage.
Identifies reasons why the engine might stop and their solutions.
Explains causes and remedies for blue smoke appearing in the exhaust.
Solutions for scenarios where the generator does not produce power.
Lists engine components with reference numbers and stock codes.
Lists fuel tank components with reference numbers and stock codes.
Lists muffler cover components with reference numbers and stock codes.
Lists panel components with reference numbers and stock codes.
Lists panel components with reference numbers and stock codes.
Lists baseplate and frame components with reference numbers and stock codes.
Lists control panel components with reference numbers and stock codes.
Lists rotor/stator components with reference numbers and stock codes.
Lists engine components with reference numbers and stock codes (Model A112002).
Lists fuel tank components with reference numbers and stock codes (Model A112002).
Lists muffler cover components with reference numbers and stock codes (Model A112002).
Lists panel components with reference numbers and stock codes (Model A112002).
Lists panel components with reference numbers and stock codes (Model A112002).
Lists baseplate and frame components with reference numbers and stock codes (Model A112002).
Lists control panel components with reference numbers and stock codes (Model A112002).
Lists rotor/stator components with reference numbers and stock codes (Model A112002).