9
GB/IE/NI
PLEASE NOTE!
The product cannot be
switched on during the charge process� It is,
therefore, not suitable for continuous
operation�
Charging the battery with the charging
cable
RISK OF ELECTRIC SHOCK!
Only charge the product in dry,
interior rooms, as the splash water
protection (IP44) cannot be guaranteed
when the micro USB charging cable is
connected�
Open the USB cover
6
that covers the
micro USB charging jack
7
(see Fig� B)
and connect the micro USB charging cable
5
contained in your package with the
charging jack
7
of your LED camping
light�
To charge the battery, connect the micro
USB charging cable
5
to a USB mains
adaptor (SELV – 5 V, max� 1 A, not
included)�
Plug the USB mains adaptor into a power
outlet�
All LEDs will start ashing and the battery
will start charging� The more LEDs light up
continuously, the higher the charge status of
the battery�
Charging takes approximately 3 hours�
When the LED camping light is fully
charged, all of the LEDs in the charge status
indicator
3
will remain constantly on�
You can now unplug the USB mains
adaptor from the socket and the USB
charging cable from the product�
Place the USB cover
6
over the jack again
to protect the product from humidity and
ensure splash water protection�
Charging the battery with the dynamo
Turn the product off (see section ‘Operation’)
so you do not slow down the charging cycle
of the product�
Fold out the dynamo crank handle
8
underneath the LED camping light (see
Fig� C)�
Turn the crank handle
8
clockwise to
charge the battery� The longer you keep
turning the crank handle, the more your
battery will charge�
All LEDs will start ashing and the battery
will start charging� The more LEDs light up
continuously, the higher the charge status of
the battery�
Fold the handle back into the designated
opening in the product’s housing when you
have nished charging.
z Cleaning and storage
RISK OF DAMAGE!
Cleaning the product incorrectly can
potentially cause damage�
Do not use any chemicals for cleaning as
this might damage the surface�
Use only a dry, lint-free cloth for cleaning� If
the product is very dirty, dampen the cloth
slightly�
The micro USB charging jack
7
must not
come in contact with moisture during the
cleaning process to prevent a short circuit
or other damage�
When the product is not in use, store inside
the packaging in a dry place�
To maintain the rechargeable battery’s
capacity, it needs to be charged for about
2 hours about every 4 months�
z Troubleshooting
= Fault
= Cause
= Solution
= The product fails to switch on�
= The product is switched off�
= Press the On/Off switch
4
to switch
the product on�
To Next Page
Loading...