EasyManua.ls Logo

Rockwood 15205 User Manual

Rockwood 15205
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
© Copyright 2014 Easthill Group, Inc. Instruction item #152058Q Rev. 9/14
If you have any questions about the use of this product, please contact
Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com
PDF version of this manual is available online >> eastwood.com/15205manual
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA
US and Canada: 800.345.1178 Outside US: 610.718.8335
Fax: 610.323.6268 eastwood.com
MAINTENANCE
LUBRICATION
• Air Cylinder - Add several drops of a good quality air tool oil before each use into the Air Inlet or use an automatic oiler. This is important to
prevent seizing of the internal actuating Air Cylinder.
• Pivot points – Using good quality automotive chassis grease dispensed with a Zerk fitting compatible grease gun, pump a small amount of
grease into the Zerk fittings as shown (Fig G).
ROTATION ADJUSTMENT
The Paint Shaker is adjusted from the factory to provide 15° side-to-side (30° total) rotational travel. If the rotation angle should ever require
adjustment, loosen lock nut and turn Adjustment Screw (Fig G) in to reduce angle, turn it out to increase angle. Re-tighten locknut.
CHECK HARDWARE
The Paint Shaker vibrates violently during operation which can loosen hardware.
Check mounting bolts, U-bolt clamps and Cradle mount bolts for tightness before each use
and re-tighten if necessary.
Fig. G
Angle
Adjustment Screw
✓
Pivot Point
Zerk Fittings
✓
✓
Item #15205
PNEUMATIC PAINT SHAKER
INSTRUCTIONS
™
Question and Answer IconNeed help?

Do you have a question about the Rockwood 15205 and is the answer not in the manual?

Rockwood 15205 Specifications

General IconGeneral
BrandRockwood
Model15205
CategoryMixer
LanguageEnglish

Summary

Pneumatic Paint Shaker Instructions

Safety Information

Read Instructions

Thoroughly read and understand this manual before use for safety, maintenance, and operating procedures.

General Warnings

Important safety warnings including secure mounting, pressure limits, and disconnecting air supply.

Included Components

Technical Specifications

Assembly Instructions

Setup and Connection

Operation

Placing Paint Can into Cradle

Instructions on how to properly place and secure a paint can into the shaker's cradle.

Shaking Paint

Steps for operating the paint shaker, including air supply, monitoring, and post-shaking procedures.

Maintenance

Lubrication

Guidance on lubricating the air cylinder and pivot points for optimal performance and longevity.

Rotation Adjustment

How to adjust the side-to-side rotational travel of the paint shaker.

Check Hardware

Instructions to check and tighten mounting bolts, clamps, and cradle mounts due to vibration.