roco LOKMAUS 2 User Manual

Content (English Text)
Features of the Lokmaus
®
220
Plug and play – wiring the Lokmaus
®
220
The RocoNet 20
Handling of the Lokmaus
®
221
Taking a loco from an other Lokmaus
®
222
The Smart-Search Function 22
The Master - Slave System 23
Function that are only available at the ‘Master Lokmaus
®
2’ 23
Setting up the Speed Steps (14, 28 or 128 Speed Steps) 23
Programming Modes and Programming Procedures of the Lokmaus
®
224
Standard Programming Procedure 24
Profressional Programming Procedure 25
Programming Modes 25
Programming the Digital Turnout Drive 42624 26
Short Circuit and Overload 26
The Booster 10762 26
Using one or more Boosters 10762 26
Analogue Locos (Locos without Digital Decoder) on Digital Tracks 27
Compatibility of the new System (RocoNet) to the old Digital System (Maus-Bus) 27
Compatibility of Control Devices and Decoders 27
The Menu System of the Lokmaus
®
228
Combination of Digital and Non-Digital Parts of a Layout 29
Installing the Separator 10768 29
A Pass-over-Section 30
Turning Loops in a digital Layout 30
Trouble-shooting 31
Error Messages 31
Compatibility of Loco Decoders 32
Devices of other Brands as Input Devices at the RocoNet 33
Lokmaus
®
2 as Input Device for other Systems 33
19
ENGLISH

roco LOKMAUS 2 Specifications

General

Brand	roco
Model	LOKMAUS 2
Category	Control Systems
Language	English

Summary

Features of the Lokmaus®2

Plug and play – wiring the Lokmaus®2

Connects the Lokmaus®2 to the RocoNet amplifier and transformer.

Handling of the Lokmaus®2

Describes the operation of the Lokmaus®2 control knob, buttons, and display.

The Smart-Search Function

The Master - Slave system

Setting up the speed steps (14, 28 or 128 speed steps)

Guides on configuring loco speed step modes globally or individually.

Programming modes and programming procedures of the Lokmaus®2

Standard Programming Procedure

Outlines the basic method for programming loco addresses and basic CVs.

Programming the CV29

Details how to set up CV29 for decoder behavior like speed steps and driving sense.

Professional Programming Procedure

Describes the advanced method for programming all CVs from 01 to 99.

Programming Modes

Programming the Digital Turnout Drive 42624

Specific instructions for programming the address of a digital turnout drive.

Short circuit and overload

Explains system response to short circuits and overloads, and how to recover.

The booster 10762

Information on when and how to use a booster to increase power capacity.

Using one or more boosters 10762

Compatibility of control devices and decoders

The menu system of the Lokmaus®2

Installing the separator 10768

Instructions for installing a separator to isolate digital and DC sections.

Turning loops in a digital layout

Trouble-shooting

Headlights don't work correctly

loco doesn't move (128 speed step mode)

sense of driving of the loco is inversed

headlights of the pilot car (e.g. of the ICE don't match direction)

the speed step mode can't be changed

the display shows the message 'PA'

Error Messages

Lists and explains various error codes displayed by the Lokmaus®2 system.