Roger Technology B70/1DC - Page 35

EN
67
11 Travel acquisition
For the system to function correctly, the barrier travel must be acquired by the controller.
11.1 Before starting:
1. Select the automation system model installed with the parameter $.
KEY:
HIGH SPEED Motors REVERSIBLE Motor
SELECTION MODEL MOTOR TYPE CONFIGURATION
D
BH30/603
BH30/604
/ 600kg IRREVERSIBLE
D
BH30/803
BH30/804
/ 1000kg IRREVERSIBLE
D
BH30/503/HS
BH30/504/HS
BH30/603/HS
BH30/604/HS
600kg IRREVERSIBLE HIGH SPEED
see chapter 14 "Special Parameters for High Speed Motor"
D
BM30/400 / 500kg IRREVERSIBLE
D
BM30/300/HS
400kg IRREVERSIBLE HIGH SPEED
see chapter 14 "Special Parameters for High Speed Motor"
D
BH30/804/R
800kg REVERSIBLE
see chapter 15 "Special Parameters for Reversible Motor"
2. Select the position of the motor relative to the gate with the parameter . The default setting for this parameter is
with the motor installed on the right hand side of the gate (seen from interior side).


OPENING ON THE LEFT
OPENING ON THE RIGHT
3. Adjust the (mechanical or magnetic) limit switches so that, once triggered, the gate stops slightly before it reaches
the mechanical stop.
CLOSING LIMIT SWITCH
OPENING LIMIT SWITCH
4. Check that the operator present function is not enabled ($ ).
OPEN CLOSESTOP
5. Move the gate into the closed position.
6. Press TEST (see TEST mode in chapter 10) and check the command signal and safety device states. If any safety
devices are not installed, jumper the relative contact or disable the device from the relative parameter (, , ,
,  and ).