Roger Technology B70/1DC User Manual

Quick Start B70/1DC
Rev02 03/04/2020
1
A
1
5
2
2
3
4
ROGER TECHNOLOGY
Via S. Botticelli 8 • 31021 Bonisiolo di Mogliano Veneto (TV) • ITALIA
P.IVA 01612340263 • Tel. +39 041.5937023 • Fax. +39 041.5937024
info@rogertechnology.com • www.rogertechnology.com
A
Power supply H07RN-F 3x1,5 mm
2
double insulated cable
1
Photocell - Receiver 5x0,5 mm
2
double insulated cable (max.20 m)
2
Photocell - Transmitter 3x0,5 mm
2
double insulated cable (max.20 m)
3
Flashing lamp unit 2x1 mm
2
double insulated cable (max.10 m)
4
Antenna RG58 50 Ohm cable for external use (max.10 m)
5
Selector / Keypad 3x0,5 mm
2
cable (max.20 m)
1. Typical installation
B70/1DC is the range of 24V DC digital controllers installed with the BH30 and BM30 product series for sliding gate applications.
EN

Roger Technology B70/1DC Specifications

General

Brand	Roger Technology
Model	B70/1DC
Category	Controller
Language	English

Summary

Typical Installation Overview

Electrical Connection Guide

Pre-Installation Checks

Automation System Model Selection

Select the automation system model installed via parameter A1 for proper configuration.

Motor Position Setup

Set the motor's position relative to the gate using parameter 71.

Limit Switch Calibration

Adjust mechanical or magnetic limit switches to ensure gate stops correctly.

Initial Closing Position Verification

Confirm the gate is fully closed and displays 'FC' when the TEST button is pressed.

System Test Button Functionality

Press the TEST button to check system status and potential alarms.

Acquisition Procedure Steps

Transmitter Programming

Transmitter Cloning

Photocell Grounding Connection