Roger Technology B70/1DC - Acquisition Procedure Steps

 Speed Speed
 Closing speed BH30/HS-BM30/HS

Approach
distance
 Approach
speed
 Approach distance
 Approach speed
 Deceleration
 Deceleration
during closure BH30/HS-BM30/HS
 Deceleration
 Acceleration  Acceleration
 Acceleration during closure
BH30/HS-BM30/HS
CLOSE OPEN
 Boost during aperture
 Boost during closure
0°
0°
 Maximum motor torque setting according to defined time
5. Acquisition procedure
1. Press and hold PROG for 4 seconds.
2. APP- appears on the display.
3. Open the release cover.
4. PHAS appears on the display.
5. Wait until the message PHAS flashes.
6. Close the release cover.
7. If the photocells are connected and enabled (FT1/FT2), the message FOTO flashes. NOTE: do not break the photocell barrier beam.
8. AUTO appears on the display.
9. The gate starts to open.
10. Once the gate is open, the message AUTO flashes on the display after a few seconds and the gate starts to close.
11. When the gate is closed, the safety device symbols are displayed.
PROG
AP P- PH A5
AU to
x4 s
x5 s
OPENING OPEN CLOSING
(if FT1/FT2 are
connected or enabled)
CLOSE
Yes
AU
AU
to
to
PH
PH
A5
A5
FO
FO
TO
TO
CLOSE
6. Setting basic parameters
 Setting motor torque
  Minimum torque
  Maximum torque
 Obstacle detection
sensitivity setting
  Maximum sensitivity
  Minimum sensitivity
 Setting reverse time after
activation of sensing edge
or obstacle detection
(crush prevention).