Roger Technology B70/1DC - Page 44

EN
76

Contact with 8k2 resistor. The gate always reverses.

Management of two 8k2 sensitive edges connected in parallel (total resistance 4k1). The gate reverses only when
opening.

Management of two 8k2 sensitive edges connected in parallel (total resistance 4k1). The gate always reverses.
 
(TSܪLZWNSLWFINTHMFSSJQ57 N.B.: With ROGER TECHNOLOGY plug-in radio receiver board.
 
(TSܪLZWNSLWFINTHMFSSJQ57 N.B.: With ROGER TECHNOLOGY plug-in radio receiver board.

STEP MODE.

PARTIAL OPENING

OPENING

CLOSING.

STOP.

Courtesy light. The output COR is managed from the remote control. The light remains lit as long as the remote control
is active. The parameter  is ignored.

Courtesy light in step mode (PP). The output COR is managed from the remote control.
The remote control turns the courtesy light on and off. The parameter  is ignored.

89*524)*\NYMHTSܪWRFYNTSKTWXFKJY^
(1)

5&79.&145*3.3,\NYMHTSܪWRFYNTSKTWXFKJY^
(1)

45*3.3,\NYMHTSܪWRFYNTSKTWXFKJY^
(1)

(148:7*\NYMHTSܪWRFYNTSKTWXFKJY^
(1)
(1)
9TUWJ[JSYLFYJRFSTJZ[WJXHFZXJIG^FHHNIJSYFQQ^UWJXXNSLFWJRTYJHTSYWTQGZYYTSHTSܪWRFYNTSNXWJVZNWJIYT
enable the command. Example: parameters   and   set:
• 5WJXXNSLYMJ(-&GZYYTSTSYMJWJRTYJHTSYWTQXJQJHYXYMJXYJURTIJKZSHYNTS\MNHMRZXYGJHTSܪWRJI\NYMNS
seconds by pressing CHB on the remote control. Press CHB to activate partial opening.
 
(TSܪLZWNSLܫFXMNSLQNLMYKWJVZJSH^

9MJKWJVZJSH^NXXJYJQJHYWTSNHFQQ^KWTRYMJܫFXMNSLQNLMYZSNY

8QT\ܫFXM

1NLMYܫFXMJXXQT\Q^\MJSLFYJTUJSXWFUNIQ^\MJSLFYJHQTXJX
 
Selecting courtesy light mode
N.B.: the parameter is not visible if par.  is different than 

Disabled.

5:18*9MJHTZWYJX^QNLMYNQQZRNSFYJXGWNJܫ^FYYMJXYFWYTKJFHMRFSTJZ[WJ

ACTIVE. The light remains lit for the entire duration of the manoeuvre.

From 3 to 90 s. The light remains lit for the time period set after the manoeuvre is completed.

From 2 to 9 minutes. The light remains lit for the time period set after the manoeuvre is completed.
 
(QTHPHTSYFHYHTSܪLZWFYNTS
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.

When the clock function is active, the gate opens and remains open. Any command signal received is ignored.

When the clock function is active, the gate opens and remains open. Any command signal received is accepted. When
the gate returns to the completely open position, the clock function is reactivated.
  
Enable safeguarded gate closure/opening
Enabling this parameter ensures that the gate is not left open due to an incorrect and/or accidental command.
This function is NOT enabled if:
• the gate receives a STOP command;
• the sensing edge intervenes, detecting an obstacle in the same direction in which the function is enabled. If
instead the sensing edge detects an obstacle during the movement opposite to the guaranteed one, the function
is maintained active.
• the number of closure attempts set by parameter $ has been reached;
• the acquired position is lost (perform position recovery, see chapter 20).

Disabled. The parameter  is not displayed.

Guaranteed closing enabled.
After a period of time set with parameter YMJHTSYWTQZSNYXNLSFQXFXJHTSI\FWSNSL\NYMYMJܫFXMNSLQNLMYWJLFWI-
less of the parameter $, and then closes the gate.