Rohde & Schwarz CMW500 Series - Page 6

Contents
R&S
®
CMW500
6User Manual 1173.9463.02 ─ 02
5.3.7 External Trigger...........................................................................................................108
5.3.8 Logging.......................................................................................................................109
5.3.9 Digital IQ.....................................................................................................................110
5.4 Instrument Setup Dialog...........................................................................................111
5.5 Measurement Controller Dialog...............................................................................112
5.6 Generator/Signaling Controller Dialog....................................................................113
5.7 Blockview Dialog.......................................................................................................113
5.7.1 Show Active Routing...................................................................................................115
5.7.2 Show Selectable Routing............................................................................................115
5.8 System Messages.....................................................................................................117
6 Remote Control..................................................................................119
6.1 Remote Control Operation.......................................................................................119
6.1.1 Drivers for Graphical Programming Interfaces............................................................121
6.1.2 Setting the Device Addresses.....................................................................................121
6.1.3 Establishing and Testing a LAN Connection...............................................................122
6.1.4 Switchover to Remote Control....................................................................................123
6.1.5 Multiple Channels for Remote Access........................................................................125
6.2 Messages...................................................................................................................126
6.2.1 VXI-11 Interface Messages.........................................................................................126
6.2.2 GPIB Bus Interface Messages....................................................................................126
6.2.3 Device Messages (Commands and Device Responses)............................................126
6.2.4 SCPI Command Structure and Syntax........................................................................127
6.3 R&S CMW Software and Command Structure.......................................................134
6.3.1 General Command Structure......................................................................................134
6.3.2 Firmware Applications.................................................................................................135
6.3.3 Measurement Contexts and Views.............................................................................136
6.4 Control of the Instrument.........................................................................................137
6.4.1 Generator Control.......................................................................................................137
6.4.2 Measurement Control..................................................................................................139
6.4.3 Signaling Generator Control........................................................................................150
6.4.4 Signal Path Settings....................................................................................................152
6.4.5 Resource and Path Management...............................................................................159
6.5 Command Processing..............................................................................................164