Need help?Do you have a question about the Rohde & Schwarz CMW 500 and is the answer not in the manual?
General| RF Bandwidth | Up to 160 MHz |
|---|---|
| Number of RF Ports | Up to 4 |
| Modulation Types/Signaling Standards/Supported Technologies | GSM, WCDMA, LTE, WLAN, Bluetooth |
| Interfaces | LAN, USB, GPIB |
| Power Supply | 100 V to 240 V AC, 50 Hz to 60 Hz |
Overview of front panel controls, connectors, and interface elements.
Basic steps for instrument setup, including unpacking, connection, and powering on.
Guidelines for connecting external devices like mice, keyboards, printers, monitors, and LAN.
Procedure for starting up and shutting down the instrument correctly.
Instructions for integrating and operating the instrument remotely via a Local Area Network.
Procedure for updating the instrument's firmware package.
Learn to perform fundamental tasks using the GUI and its control elements efficiently.
Step-by-step example of generating and measuring an RF signal.
Overview of the R&S CMW 500's RF generator capabilities and control methods.
Overview of the instrument's measurement capabilities and principles.
Shows startup progress and options, replaced by last session's dialog upon completion.
Dialogs for administrative tasks, instrument reset, and accessing information.
Manages basic and administrative tasks, including system settings and option activation.
Instructions for setting up the tester for remote control via LAN, USB, or GPIB interfaces.
Understanding the structure, syntax, and mnemonics of SCPI commands.
Principles of measurement and generator control via SCPI commands.
System for storing and reporting instrument state and error information.
Explains SCPI command syntax elements and notation used in reference sections.
Lists standard IEEE 488.2 commands with consistent effects across devices.
Commands for mass memory access, status structure control, and administrative tasks.
Functions for system configuration, including LAN services and general settings.
An alphabetical listing of system-related commands and their corresponding page numbers.
Covers RF signal measurements and generation capabilities for general-purpose RF testing.
Detailed reference for parameters of the General Purpose RF application GUI.
Provides programming examples for controlling GPRF generator and measurements via remote control.
Detailed reference for remote control commands specific to the GPRF application.
Provides TX tests on GSM uplink signals for power, modulation, and spectrum.
Detailed reference for parameters of the GSM application GUI.
Provides programming examples for GSM firmware applications.
Detailed reference for remote control commands of the GSM application.
Provides TX tests on WCDMA FDD uplink signals for power, modulation, and ACLR.
Detailed reference for parameters of the WCDMA application GUI.
Provides programming examples for WCDMA firmware applications.
Detailed reference for remote control commands of the WCDMA application.
Tests on uplink OFDMA signals for power, modulation, and spectral flatness.
Detailed reference for parameters of the WiMAX application GUI.
Detailed reference for remote control commands of the WiMAX application.
Detailed description of the rear panel connectors and their functions.
Details on the LAN interface, network card, and protocols (VXI-11).
Information on GPIB bus interfaces, including connectors and characteristics.
Comparison of R&S CMW 500 features with R&S CMU and migration hints.
To Next Page