R&S
®
CMW 500 Remote Control
Control of the Instrument
Operating Manual 1202.3986.32 – 03 96
Two measurements in conflict, second measurement queued
Generator and measurement in conflict
Two non-conflicting measurements, executed in parallel
5.4.8.2 Queuing of Measurements
The R&S CMW 500 queues conflicting measurements in order to ensure that no
results are lost when a new measurement is started. Adding a new measurement to
the queue switches the preceding measurement into single shot mode (if it is a
continuous measurement). As a result, the instrument can acquire a valid set of
measurement results for every measurement in the queue.
Example for queued conflicting measurements
*RST
INITiate:<FWA>:<Meas1>
Start measurement 1 in single shot mode
(default setting for remote control)
INITiate:<FWA>:<Meas2>
Start a new measurement 2. The new
measurement will be queued.
To Next Page
Loading...
