Rohde & Schwarz CMW 500 - Configure:gsm:meas<I>:Mevaluation:trigger:delay; Configure:gsm:meas<I>:Mevaluation:trigger:threshold

R&S
®
CMW 500 GSM Applications
GSM Command Reference
Operating Manual 1202.3986.32 – 03 262
CONFigure:GSM:MEAS<i>:MEValuation:TRIGger:SOURce <Trigger Source>
Selects the source of the trigger events.
<Trigger Source> ACQuisition: Frame trigger according to defined burst pattern
POWer: Power trigger (received RF power)
FRUN: Free Run
Def. value: POWer
Example See Specifying Measurement-Specific Settings
Characteristics Firmware version V1.00
CONFigure:GSM:MEAS<i>:MEValuation:TRIGger:SLOPe <Trigger Event>
Qualifies whether the trigger event is generated at the rising or at the falling edge of
the trigger pulse (valid for the power trigger sources; see
CONFigure:...:MEAS<i>:...:TRIGger:SOURce).
<Trigger Event> REDGe: Rising edge
FEDGe: Falling edge
Def. value: REDGe
Example See Specifying Measurement-Specific Settings
Characteristics Firmware version V1.00
CONFigure:GSM:MEAS<i>:MEValuation:TRIGger:THReshold <Trigger
Threshold>
Defines the trigger threshold for the power trigger sources; see
CONFigure:...:MEASurement<i>:...:TRIGger:SOURce).
<Trigger Threshold> Range: –50 dB to 0 dB
Def. value: –30 dB
Def. unit: dB (full scale, i.e. relative to the expected nominal
power of the power steps that generate the trigger events)
Example See Specifying Measurement-Specific Settings
Characteristics Firmware version V1.00
CONFigure:GSM:MEAS<i>:MEValuation:TRIGger:DELay <Trigger Delay>
Defines a delay time (integer number of GSM timeslots) for all trigger sources except
"Free Run" (CONFigure:GSM:MEAS<i>:MEValuation:TRIGger:SOURce). The
parameter delays the start of the measurement relative to the trigger event.
深圳德标仪器 135-1095-0799