R&S
®
CMW 500 GPRF Applications
GPRF GUI Reference
Operating Manual 1202.3986.32 – 03 148
WinIQSIM 2 is installed on an external PC and does not require any additional
hardware to generate the waveform files. Transmission of the files to the R&S CMW
500 is menu-guided; refer to the WiNIQSIM2 manual. Preferably, a LAN connection is
used, and the waveform files are stored under D\:Waveform.
Available waveforms and options
The R&S CMW 500 supports "Custom Digital Modulation" signals generated by
WinIQSIM2. Network-specific signals (uplink and downlink) can be downloaded with
the following options:
GSM, GSM + (E)GPRS: Option R&S CMW-KW200, GSM WINIQSIM2
WCDMA (3GPP FDD): Option R&S CMW-KW400 WCDMA WINIQSIM2
WCDMA (3GPP FDD) + HSDPA: Option R&S CMW-KW401 WCDMA HSDPA
WINIQSIM2
WCDMA (3GPP FDD) + HSUPA:Option R&S CMW-KW402 WCDMA HSUPA
WINIQSIM2
WiMAX (IEEE 802.16): Option R&S CMW-KW700 WIMAX WINIQSIM2
GPIB command:
SOURce:GPRF:GENerator<i>:ARB:FILE
7.2.1.5 List Mode
In list mode, the RF generator steps through a list of configurable frequencies and
powers.
List Configuration > List Section
Definition of the step range to be used in all list modes except "Step". The generator
steps through all list entries between the "Start Index" and the "Stop Index" in the
"Frequency / Level List". The total number of generated steps (Result Count = Stop
Index – Start Index + 1) is displayed for information.
GPIB command:
SOURce:GPRF:GENerator<i>:LIST:SSTopSOURce:GPRF:GENerator<i>:LIST
:COUNt?
To Next Page
Loading...
