R&S
®
CMW 500 Basic Instrument Functions
Setup Dialog
Operating Manual 1202.3986.32 – 03 66
Internal Reference Frequency
Indication of the fixed internal 800 MHz frequency (no setting value).
External Reference Frequency
Value of the external reference frequency. If "Frequency Source: External" is used this
value must be equal to the frequency of the signal fed in at the rear panel connector
REF IN. Besides the external reference signal must meet the specifications of the data
sheet.
GPIB command: CONFigure:SELFtest:REFerence:FREQuency
4.3.4 Measurement Controller Dialog
The "Measurement Controller" dialog gives an overview of all available measurement
firmware applications, starts or stops measurements.
Measurement Controller dialog
Use the "Control" buttons in the dialog to switch the selected measurement on or
off, stop or restart the measurement (see Measurement Control).
Alternatively, with a particular measurement selected, use the ON / OFF or
RESTART / STOP front panel keys to switch the measurement on or off.
Notice that different measurement and generator firmware applications can be active
simultaneously. E.g. all GPRF measurements and the GPRF generator can be active
at the same time.
4.3.5 Generator Controller Dialog
The "Generator Controller" dialog gives an overview of all available generator firmware
applications, starts or stops generators.
Generator Controller dialog
To Next Page
Loading...
