R&S
®
CMW 500 WiMAX Applications
WiMAX Command Reference
Operating Manual 1202.3986.32 – 03 397
repetition mode specifies whether the measurement is stopped after a single shot or
repeated continuously. Use CONFigure:..:MEAS<i>:...:SCOunt to determine the
number of measurement intervals per single shot.
<Mode> SINGleshot: Single shot measurement
CONTinuous: Continuous measurement
Def. value: SINGleshot
Characteristics Firmware version V1.00
Note: in the current firmware version, this command has no
effect. The measurement is always performed in single shot
mode.
CONFigure:WIMax:MEAS<i>:MEValuation:SCOunt <Count>
Specifies the statistic count of the measurement; see Statistical Settings. The statistic
count is equal to the number of measurement intervals per single shot. Use
CONFigure:...:MEAS<i>:...:REPetition SINGleshot | CONTinuous to
select either single shot or continuous measurements.
<Count> Number of measurement intervals. A measurement interval
comprises a single power/frequency step.
Range: 1 to 10000
Def. value: 10
Characteristics Firmware version V1.00
10.3.2.4 Measurement Parameters
The following commands adjust the analyzer of the R&S CMW 500 to the properties of
the analyzed signal.
CONFigure:WIMax:MEAS<i>:MEValuation:BWIDth <Bandwidth>
Sets the IF bandwidth of the R&S CMW 500. Set this parameter in accordance with the
channel bandwidth of the measured OFDMA signal.
<Bandwidth> Range: 3.5 MHz | 5 MHz | 7 MHz | 8.75 MHz | 10 MHz
Def. value: 10
Unit: MHz
Characteristics Firmware version V1.00
CONFigure:WIMax:MEAS<i>:MEValuation:LMODe <Link Mode>
Selects the link and the sub-channel allocation mode. The R&S CMW 500 can analyze
UL signals with partial usage of sub-channels (UL-PUSC).
To Next Page
Loading...
